|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
SF-S55 H. Adjusting the parallelism of bin unit aligning bar 1. Put A4 papers (about 10 sheets) into the upper limit and lower limit trays in contact with the reference bar. 2. Insert the screwdriver through the holes "a" and "b" of non-sort bin, and loosen the screws (2 pcs.). 3. Keep the aligning bar pressed against the adjusting plate with your fingers. 4. Insert the screwdriver through the hole "b" of non-sort bin, and tighten the screw. 5. Insert the screwdriver through the hole "b" of non-sort bin, and tighten the screw. 6. Pull the lower side of aligning bar, press it again against the adjusting plate, and make sure that the upper side and lower side contact at the same time. 7. Pull out paper. I. Adjusting the lead cam position 1) Remove the E-ring (2), and remove the flange (1) of lead cam shaft gear at the front side.
� �
� �
2)
Remove the belt (4) from the gear (3), and turn the lead cam (5) to align the position of front lead cam with the rear lead cam.
Aligning bar
A4 paper
5�5
|
