HUSQVARNA SG13
Instrukcja Obsługi

RUNNING
5. 6. Hold in the the dead man�s grip bar and start the engine. Allow the engine to warm up for two minutes at idle before grinding.

8011-185 8011-127

7.

Tilt the machine on its wheels, lifting the cutting wheel off the ground/tree stump.

8011-202

8.

Set the throttle to ENGAGE.

8011-194

IMPORTANT INFORMATION If the cutting wheel is too low, the machine may start to �climb� over the stump and become instable. 9. Place the middle of the cutting wheel approximately 2.5 cm above and 2�4 cm into the stump.
8011-203

10. Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about 2.5 cm after each pass until the front edge of the stump is gone. 24 � English