|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
MAINTENANCE
WARNING!
The cutters can come loose from the cutting wheel if the screws are not sufficiently tight. Comply with the recommended torque settings. Hold the teeth (30-31) in place as in the upper diagram when mounting the pockets (32-33). Risk for incorrect assembly. Insert the screw (34) in one pocket (32), through the blade section (28) and out though the pocket (33) on the other side. Make sure that the roll pins in the back edge of the teeth are seated against the back of the pockets. This provides the correct gauging of the cutter edge. Tighten the screws 120 - 150 ft/lbs. (162-203 Nm). Insert a bar through the extra holes in the cutting wheel to act as a stop when removing and attaching the cutting teeth and bearings.
8011-216
Removing and refitting the wheels
To remove the left wheel (8) from the stump grinder, remove the locking collar (9), the 1/4� screws (10), the 1/4� hex nuts (3), the springs (4) and the brake pad (7). The wheel can now be removed from the axle. To remove the right wheel (2), remove the locking collar (1) and slide the wheel off the axle.
FRONT
RIGHT
LEFT
8011-217chg
38
|
|
|
> |
|
