Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 20 (kliknij aby zobaczyć)
Mount the decor panel by inserting the two pivots of the cross-bar into the slotted holes of the door.
Adjusting the door balance
The door of the dishwasher is balanced when it stands still in any position, if opened. Fitting the decor panel may sometimes affect this balance. In this case it will be necessary to adjust the balance as follows: Half-open the door and regulate the screws located on the kick plate.
II12
Lift the decor panel until perfect alignment with the facia panel is obtained: if the two brackets have also been used, they will automatically enagage in the special holes provided on the dishwasher door. Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two long 4 x 40 screws provided, using the holes through the inner door (see fig.).
II08
By screwing or unscrewing these screws by the same amount, the tension of the door balancing springs is increased or decreased respectively. Warning! The weight of the panel should be within the limit given in the "dimensions of the panel", otherwise balancing the door will not be possible.
II10
Levelling Fixing to adjacent units
Insert the two fixing brackets into the slots provided in the top front part of the dishwasher, as shown in the figure. Secure the brackets to adjacent units using two 3,5 x 16 screws using the upper or side holes. Make sure that the dishwasher door closes properly, without any friction on the sides. Otherwise level the machine by slightly screwing or unscrewing the two front feet until perfect closure of the door is achieved.
II29
Important! The dishwasher must be secured against tilting. Therefore, make sure that the counter it is fitted under, is suitably secured to a fixed structure (adjacent kitchen cabinets, wall). Warning! When the dishwasher is secured to the kitchen cabinets, be sure not to drill any holes into the sides of the machine.
20
