MIXER FEATURES
1. Input fader - Controls individual source levels (channels) in the mix. 2. Input toggle switch - Selects which source will be active based on what you have connected to the rear panel input section (phono/line). 3. Treble and Bass EQ - Adjusts the high and low frequency levels of the input channels for good sound. 4. Channel Gain � Adjusts the pre-fader volume for cleaner sound. 5. Replaceable Crossfader - Achieves clean segues between the two input channels. "Hard left" selects Channel 1. "Hard right" selects Channel 2. With the crossfader centered, both assigned channels are live. Use the crossfader for fast and seamless segues (fades) from one selected channel to the other. Note: The crossfader is user replaceable in case of failure. Simply unscrew the two large screws which hold it in place, lift it out and disconnect it�s cable. Re-attach the new crossfader and screw the mounting plate back onto the unit - you�re back in business! 6. Mic Input Gain � Adjusts microphone input level. 7. Mic Input � Insert your Microphone with ¼� plug in here. 8. Headphone Input � Insert in the ¼� plug for your headphones here. 9. Channel Cue / Cue Pan - Used to preview channel audio to your headphones. Listen here before bringing up channel faders or moving the crossfader. 10. Headphone Level � Adjusts cue volume. 11. Master Fader - Controls the overall output level.
REAR PANEL
17 16 15 14 13 12 12. Ground - Grounding post for turntable connection. Always use this connection when using standard turntables with ground cable. (Some turntables like the STR8-80 /100 do not require grounding wire) 13. Phono Inputs � Plug your turntables in here. When these connectors are used, your signal is fed directly to the high-quality RIAA phono pre-amplifiers. Use this position only for turntables. Line level sources will overload the sensitive phono pre-amps and will cause distortion. 14. Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, laser discs, tuners, even synthesizers or other mixing consoles. NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector. 15. Stereo Main Outputs - Unbalanced RCA connectors controlled by the Master fader. 16. Power Connector - Plug in power adapter here and check the voltage level to match your country�s standard. 17. Power Switch � turns unit off and on. Note*** Remember to turn ALL volume levels down when turning on/off the unit.
