SONY SRFHM01V
Instrukcja Serwisowa

SRF-HM01V SECTION 1 GENERAL
POWER ON/OFF Hang the hooks on your ears. Neckband Neckband Hook (L, R) Battery compartment lid

This section is extracted from instruction manual.

L (Left)
TV/WB/FM SENS DX/LOCAL Driver Unit

R (Right)
VOL*1 TUNE +*2/� Display Light reflector (R, L)
This reflector reflects car lights at night for your safety. *1 There is a tactile dot beside volume to show the direction to turn up the volume. *2 The TUNE + button has a tactile dot.

BAND

MEGA BASS/CLOCK ENTER

MODE

Setting the Clock
The clock time display of this unit is a 12-hour system. When the battery is first installed, �AM 12:00� flashes in the display.

Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is factory-set to 10 kHz. Change the settings as shown below to be able to listen to the radio. Area North and South American countries Other countries Channel step 10 kHz 9 kHz

1 2

Set POWER to OFF to turn off the power. Hold down MEGA BASS/CLOCK for more than 2 seconds until �AM 12� starts flashing.

Note When the AM channel step is changed, only the preset stations on the AM band will be initialized.

3

Press TUNE + or � to adjust the hour, then press MEGA BASS/CLOCK.
If you hold down TUNE + or �, the digit changes rapidly. �AM 12:00 �= midnight, �PM 12:00 �= noon.

1 2

Set POWER to OFF to turn off the power. While holding down MODE, hold down TUNE + or � for more than 5 seconds.
The channel step will change and �9� kHz (or �10� kHz) will flash for 3 seconds in the display. If you proceed to step 2 again, the channel step changes again.

4

Repeat step 3 above to adjust the minute.
�:� starts flashing and the clock starts operating. To set the current time exactly to the second, adjust the minute and then press MEGA BASS/CLOCK to synchronize with a time signal (such as the telephone time signal).

Note If you do not press TUNE + or �, or MEGA BASS/CLOCK within one minute, the clock setting mode will be canceled.

3