|
|
|
Kto jest w sklepie?
Sklep przegląda 6018 gości i
1 zarejestrowany klient |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Manual_SRU5170_87
24-04-2007
15:50
Pagina 11
Instructions for use 5. Replacing the batteries
When the battery status indicator ( ) on the display starts blinking, battery power is low and you should replace the batteries. All user settings will be retained when the old batteries are removed.
1 2 3
Press the cover inward, slide it in the direction of the arrow and remove the cover. Insert 3 AAA/R03 batteries noting the + and configuration inside the battery compartment. Place the cover back and click it firmly into place.
6. Support Troubleshooting
� � � � � � Problem Possible cause / solution The device you want to operate does not respond at all when a key is pressed. Point the remote control at the device and make sure that there are no obstructions between the remote control and the device. Make sure the function you wish to operate is available on the device. Check if the battery status indicator ( ) on the display blinks (low battery power). If this is the case, insert new batteries. The device you want to operate does not respond properly when a key is pressed. Maybe the wrong code is programmed for the device during setup. Try setting up the remote again. If the device still does not respond, call our helpline. Check if the battery status indicator ( ) on the display blinks (low battery power). If this is the case, insert new batteries. The teletext keys do not work. Find out whether your TV is equipped with teletext. You have difficulties operating all of the functions on your device. Maybe the remote control has to be adapted to the model of the device. Call our helpline for details. ERROR appears on the display while adding an extra (advanced) function or when trying to learn a key. No signal from the original remote control is received for 20 seconds and the SRU 5170 stopped the adding / learning process. Start again from step 1. An SRU 5170 key is pressed before a signal is detected and the SRU 5170 stopped the adding/learning process. Start again from step 1. The function you try to add is not available on the original remote control. Make sure the original remote control is working properly. Make sure the remote controls are properly aligned. The IR signal of your original device is out of range. The SRU 5170 can only learn IR signals with a carrier signal of 30-60kHz.
� � �
� � � �
� � � � � � �
11
English
|
|
|
> |
|
