Surface Burners 0IO on ,� PO 0 B
TYPICAL TOP BURNER FLAME
To remove the cooktop, follow the instructions on pagel3. Wipe off surface burners with warm soapy water and a soft cloth after each use. Occasionally check surface burner flames for size and shape as shown. If flames do not burn properly, you may need to remove the surface burners for cleaning (see pagel7) or call a qualified technician for burner adjustments,
To adJust the HI and LO settings 2. Wlthout changing the burner on the control settings, knobs:
1. Turn on the surface burners, then set the controls on LO.
remove the control knobs. 3. Firmly grasp the control stem and insert a small bladed screwdriver into the end of the stem. Turn the screwdriver in either direction until the flame height isYe in (.318cm) or lower in size. Flame must be large enough to
malntaln a STABLE FLAME on all burner ports. NEVER ADJUST THE FLAME SIZE AT THE MEDIUM SETTING.
The Oven Door
sier to clean the oven.
Open the door to the first stop position. 2. Hold the door at both sides and lift off of hinges at bottom corners of door. 3. To replace, fit the bottom corners of the door over the ends of the hinges. Push the door down evenly. The door will close only when it is on the hinges correctly.
