|
|
|
Kto jest w sklepie?
Sklep przegląda 5988 gości i
22 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
S-W80S
7. GENERAL INFORMATION
7.1 DISASSEMBLY
Removing the Amplifier Assy
1 ) The Amplifier Assy is attached to the cabinet by 4 external screw 1. To detach it, pull down the subwoofer toward the left side. Then unfasten those screws 1 (� 4) 3 ) The SW. Assy and LED ASSY is attached to the front panel by each 2 screws. To detach them, remove the Amplifier Assy first. Then unfasten each screws from the cabinet back side.
Be sure to bind the POWER SW lead and LED lead by the cable holder(twist-lock).
LED ASSY SW. ASSY
Screw1
2 ) Stand up the speaker again. After unfastening the rear panel screw 2 (� 8), pull straight the Amplifier Assy toward back about 13cm. Then remove the connecting cord of SW. Assy and LED Assy. Next, pull out the Amplifier Assy and remove the speaker cords.
2 2 2 2
Bind the SP lead by the binder.
Removing the Subwoofer
1 ) The speaker element is attached to the back board by 4 external screws 3 and washers. To detach it, unfasten those screws and washers. 2 ) When attaching the speaker, face its terminal downward. (Screws must be used with washers.)
LINE LEVEL
INPUT OUTPUT
SPEAKER LEVEL
R
L
OUTPUT
2
INPUT
2
+ -+
3
3
2
2
Rear Panel
3
Bind the Power SW lead Amplifier Assy and LED lead by the binder.
3
Be sure to fix the lead between CNTL-ASSY and POWER ASSY to the chassis by the binder.
50
Hz
200
LINE LEVEL
INPUT OUTPUT
SPEAKER LEVEL
R
L
OUTPUT
INPUT
+
-
-+
Removing the Front Panel
The front panel is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side.
Be sure to bind the secondary side lead of the transformer by the binder.
17
|
|
|
> |
|
