PANASONIC SXPR54M
Instrukcja Obsługi

Part VI
Sound

Sound

Part Setting
Set the various sound attributes for each part.

3. Use the buttons below the display to adjust
each attribute (explained in detail following).
� The settings display is comprised of 5 pages. Use the PAGE buttons to switch pages.

Selecting an attribute
1. On the SOUND MENU display, select PART
SETTING.

4. When you have completed adjusting all of the
settings for one part, select another part and repeat the adjustment procedure as desired.
� The settings and effects of the PAN, EFFECT etc. may differ depending on the sound.

2. Use the PART SELECT � and � buttons to
select the part.

<PAGE 1>

TUNING: Use the TUNE � and � buttons to adjust the fine tuning (�128 to +127).
� The � button is used to lower the pitch, and the to raise the pitch.

� button

<PAGE 2>

SOUND: Use the SOUND � and � buttons to select a sound.
� The buttons on the control panel may also be used to select a sound.

VOLUME: Use the VOL � and � buttons to adjust the volume (0 to 127). PAN: Use the PAN � and � buttons to adjust the stereo balance (L64�CENTER(CTR)�R63).
� At L64, the sound is completely to the left, at R63 completely to the right. At CENTER, the sound is at the center. The display indicates the selected position. � Even at the same numerical value, the stereo balance may differ slightly depending on the sound.

REVERB DEPTH: Use the REVERB � and � buttons to adjust the depth of the REVERB (0 to 127). DIGITAL EFFECT: Use the DIG. EFFECT ON/OFF buttons to set the DIGITAL EFFECT to on or off. CHORUS: Use the CHORUS ON/OFF button to set the CHORUS to on or off. Use the � and � buttons to adjust the depth of the effect (0 to 127). MULTI: Use the MULTI ON/OFF button to set the MULTI EFFECT to on or off. Use the � and � buttons to adjust the depth of the effect (0 to 127). <PAGE 3>

SUS PEDAL: Use the SUSTAIN � and � buttons to adjust the length of the sustain (1-8). Use the ON/OFF buttons to enable or disable the sustain effect, when the sustain pedal is depressed. KEY SHIFT: Use the KEY � and � buttons to specify the amount of key shift (�24 to +24).
� A value of 1 means a shift of one semi-tone. To raise (or lower) the pitch one octave, set the value to +12 (or �12). � The � button is used to lower the pitch, and the � button to raise the pitch.

102
QQTG0701