|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
7 Precautions
Before connecting: � Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged. � The impedance of the speaker is 6 �. If this does not match with the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier. � The maximum power handling capacity of the SX-WD8 is 150 W. Excessive input will result in abnormal noise and possible damage. � Be sure to turn down the volume level on the amplifier to prevent unwanted noise before performing following operations: � Turning on or off other components � Operating the amplifier � Tuning FM stations � Fast-forwarding a tape � Continuously reproducing high frequency oscillation or high pitch electronic sounds � Connecting or disconnecting a microphone � When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers. � Before replacing the cartridge, always turn off the power both to the amplifier and to the turntable; otherwise, the clicking noise may damage the speakers.
The speaker grille is removable as illustrated below:
Projections Holes
Speaker grille
Speaker grille
7 Connecting the speaker system to the amplifier
� Twist and remove the insulation at the end of each speaker cord before connecting. To remove the speaker grille, insert your fingers at the top of the speaker grille, then pull towards you. Repeat the procedure at the bottom of the speaker grille.
1
2
3
To attach the speaker grille, put the projections of the speaker into the holes of the speaker grille. � Do not push the speaker grille strongly.
· terminal (Black hoop)
Specifications
ª terminal (Red hoop)
Type: Speakers Mid and low range: Tweeter: Power handling capacity: Impedance: Crossover frequency: Frequency range: Sound pressure level: Dimensions (W x H x D): Mass: Supplied accessories:
2-way 3-speaker bass-reflex type Magnetically-shielded type 10.5 cm wooden cone 2.0 cm wooden dome 150 W 6� 3 800 Hz 50 Hz to 50 000 Hz 84.5 dB/W�m 143 mm x 405 mm x 249 mm 6.3 kg � Feet (4) � Speaker cord (3 m) (1) � Screw hole caps (2)
Silver
Copper
To the speaker ª terminal of amplifier To the speaker · terminal of amplifier
� Make sure to match the polarity (ª and ·); otherwise, the surround effect will become less effective.
Design and specifications subject to change without notice.
5
English
Connection
About Speaker Grille
|
|
|
> |
|
