WAVE EXPANSION BOARD SY-EW03NX Installation instructions
CAUTION � Installation/removing
should be CARRIED OUT BY YOUR DEALER. � Failure to turn off the power to the main unit before installing/removing this board may result in damage to the main unit or this board.
Installation procedure 1. Remove the cover from the bottom of the � Open the silver cover (KN6000/6500). 2.
main unit.
EXP1
Insert the SY-EW03NX Wave Expansion Board into a slot. � To ensure proper functioning of the board, it must be inserted firmly all the way in. � Do not insert two or more SY-EW03NXs in the slots. Use the screws removed in step 1 to replace the cover on the bottom of the main unit.
If the WAVE EXPANSION BOARD is installed by the customer, we cannot accept responsibility for any malfunction of the WAVE EXPANSION BOARD or the main unit.
WAVE EXPANSION BOARD SY-EW03NX Einbauanweisungen
VORSICHT � Es wird empfohlen, den Einbau oder Herausnehmen VON
IHRER KUNDENDIENSTWERKSTATT VORNEHMEN zu lassen. � Wenn Sie Stromversorgung zu der Haupteinheit nicht vor dem Einbau oder Herausnehmen der Leiterplatte abgeschealtet wird, kann dies zu einer Beschädigung der Haupteinheit und/oder des Leiterplatte hühren.
Setzen Sie die SY-EW03NX-Platine in einen der Schlitze (slot) ein. � Um ein einwandfreies Funktionieren der Leiterplatte zu gewährleisten, mü� die Leiterplatte fest bis zum Anschlag eingeschoben werden. � Niemals zwei oder mehr SY-EW03NX-Platinen gleichzeitig in die Schlitze einsetzen. Verwenden Sie die in Schritt 1 heraus gedrehten Schrauben, um die untere Abdeckung wieder anzubringen.
Wenn dieses WAVE EXPANSION BOARD vom Kunden selbst installiert wurde, können wir keine Verantwertung für Funktionsstörungen des WAVE EXPANSION BOARD oder der Haupteinheit übernehmen.