jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 13 (kliknij aby zobaczyć)
d. Make sure that the triangular mark �A� of the L LOADING Ass�y is aligned with the mark �b� of the R LOADING Ass�y. (Fig. 4.4) e. Reference hole �C� of the LOADING RACK should be aligned with the reference hole of the R LOADING Ass�y to make the teeth of the LOADING RACK is aligned as shown in Fig. 4.4.
3-2. Adjustment and measurement of the BACK TENSION (Fig. 4.5, 4.6)
a. Check that the location of the TENSION POLE is in the right position. If not, adjust that by refering to the �4. Adjustment of the position of the TENSION POLE�. b. Playback a completely rewound T120 tape for 20 seconds. (Generally tape transporting section is settled down in 20 seconds) c. Measure the BACK TENSION by using the TENTELO METER. (Refer to Fig. 4.5) The result should be within the range of 20g~30g. d. If the BACK TENSION is out of the range, change the position of the TENSION SPRING of repeat the process of �4. Adjustment of the position of the TENSION POLE�. (Fig. 4.6) CAUTION: � If the measurement result is greater than the upper limit, change the hook point of the spring to position �A�. � Confirm that all of the three probes of TENSION meter are in contact with the tape. � During measuring, don�t touch any other parts of the MECHANISM(i.e, MAINBASE). It is recommended that this measurement be repeated at least three times for an accurate reading.
FIg. 4.4 Assembly reference between the LOADING RACK and the LOADING LEVER ASS�Y
