|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
PRECISE SITE SURVEY
Based on your general site survey, you probably already know where you want to mount your dish, but it�s a good idea to follow the procedures outlined in this section in order to make sure that your site selection is a good one. 1. Go outside to your install site and hold a compass flat in the palm of your hand. Hold your hand still until the needle stops moving (the dark or colored half of the compass needle always points North). 2. Rotate the compass so that the �N� (for North) is directly under the dark part of the compass needle. Your compass is now aligned with North. The marks around the outside edge of the compass represent the azimuth degrees you will point your antenna to.
3. Locate the tick mark on the compass edge that corresponds to the azimuth number you wrote down. This is the direction of your azimuth setting (the direction the dish will need to be pointed to receive signals from the satellites). Pick a landmark or lay down a stick in that direction for reference from the mounting location.
Ti p
Try to keep the compass away from any metal objects. Metal objects can cause inaccurate compass readings.
4. Raise your arm to approximately the elevation angle recorded earlier to make sure that there are no obstructions in the signal path. Use an inclinometer or protractor to more accurately estimate the elevation angle.
WARNING
Do NOT install the dish near power lines, electric lights or power circuits. Contact with power lines, lights or power circuits may be fatal. It is strongly recommended that the dish be located more than 20 feet from overhead power lines.
5. Repeat this survey in several places on your property if necessary until you find the best mounting location. From this rough sighting, allow plenty of clearance for the final alignment. Remember trees grow up and out, which may possibly block the signal in the future. -7-
|
|
|
> |
|
