Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 32 (kliknij aby zobaczyć)
Operating peripheral equipment using the remote control
Programming Without A Code (When the code is not known)
This procedure searches all codes and is called the �sequence method.�
1 2
SAP
POWER
Confirm that the external component is plugged in and on.
Turn the component off.
CH
3
VCR
DBS/CBL
DV D
POWER
+
OK
VOL CH VOL
CH
for at least 5 seconds. After 5 seconds, all the illuminated mode keys will begin to flash. Release the POWER and OK key. Press POWER and OK together,
T V
OK
VOL CH
MENU
VOL
VT
4
RETURN EXIT MUTE GUIDE
VCR
DBS/CBL
DV D
Press the mode key. The mode key will illuminate steadily, all others will go out.
TV/VIDEO
RECALL
1 4 7
R-TUNE
2 5 8 0
3 6 9
SLEEP PROG
5
CH
Press to move forward to the next code, or to move backward.
VOL
OK
VOL
CH
REW
PLAY
FF
PAUSE
STOP
REC
ASPECT TV/VCR
VCR/DBS CH
6
TV
POWER
Press the Remote Control
POWER
to test the component. If the
procedure was successful, the component will turn on. Note: Repeat the above steps until the component code is found. It may take many attempts before the correct code is found.
7
VOL
OK
VOL
CH
After the code is found, press OK to store the code.
CH
Note: The step and set mode will start from the current device (not the beginning of the list, except for the first time).
