ONKYO TX-SV373
Instrukcja Obsługi

Connecting antennas
Antenna cables

1

2

3

1. Press down the lever. 2. Insert the wire into the hole. 3. Release the lever to replace it.

AM loop antenna
Assemble the loop antenna as shown in the illustration. (Refer to the next page for details on connecting the AM loop antenna.)

Insert into the slot.

75/300 ohm antenna adapter (worldwide and some other models)
Outdoor FM/TV antenna Indoor T-shaped antenna

300 ohm ribbon wire

Connecting the T-shaped antenna or 300 ohm ribbon wire to the 75/300 ohm antenna adapter: Loosen the screws and wrap the wires around them. Then, tighten the screws with a screwdriver.

1

2
Slit B

3
3 3 33 3 3 3 33 3 3

Connecting the coaxial cable to the 75/300 ohm antenna adapter: 1. With your �ngernail or a small screwdriver, pull the stoppers outward and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the diagram. Connect the coaxial cable to the 75/300 ohm antenna adapter. 1 Insert the end of the cable. 2 Clamp it in place with pliers. 4. Re-install the cover.

636 mm mm mm

15mm

Wire A Slit C

1

2

Directional linkage
Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.

Directional linkage type splitter To TX-SV373/TX-SE350 To TV (or VCR)

12