Operating Sequence
Before using your tumble dryer for the first time, we recommend you place a few damp cloths inside the appliance and dry for 20 minutes. There may be dust inside a brand new tumble dryer.
After each use
� Switch the appliance off by releasing the ON/OFF button . The mains-ON light goes out. � Clean the filters (see page 9). � Empty the water reservoir (see page 10). Important! If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance. Modifying the programme
Drying
1. Connect the appliance. 2. Open the door.
P1149
P1108
3. Load the items one at a time, shaking them out loosely. 4. Close the door. Please check the laundry does not get caught between the door and filter. 5. Press the ON/OFF button comes on. 6. Select the drying time. 7. If required, press the low temperature button or the Cool Tumble button . 8. Press the Start button operating . : the machine starts : the mains-ON light
To change a programme which is running without opening the door, first depress the ON/OFF button and then turn the time selector dial to the required time. Press the ON/OFF button again.
The drum turns alternately in both directions during drying. All drying programmes end with a 10 minute cooling phase (position on selector dial). The machine stops automatically at the end of this phase. 9. Release the ON/OFF button (the mains-ON light goes out) and immediately remove the laundry.
