WHIRLPOOL TD50G0
Instrukcja Obsługi

Good air circulation is needed for best performance-allow at least 12-l 8 inches (30.5 45.7 cm) of air space on all sides of the dehumidifier.

EMPTY/ADJUST light: BUCKEI
If this light is on, the dehumidifier is not running.This light indicates that you need to check: l If the bucket is full, empty bucket and replace.
l

DRYNESS CONTROL:
This controls the amount of moisture in the room.Turn the control knob clockwise for more drying.Turn the control knob counterclockwise for less drying.Turn control knob to�NORMAL� to maintain average humidity conditions. NOTE: For the first few days of use, turn the Dryness Control clockwise to �DRYEST�to remove extra moisture from the furnishings as well as the room air. :�

If the bucket is not in position,
remove bucket and replace. Make sure the bucket fits all the way into the dehumidifier and the light is off or dehumidifier will not run.
�... �... �... . . ..

Install dehumidifier on a level floor strong enough the dehumidifier with a full bucket of water.

to support

where the temperature will not fall below 65°F (18.3�C). Lower temperatures will cause ice to form on coils.

When moving dehumidifier, use the grip areas with both hands to push dehumidifier to a new location. Do not lift the dehumidifier with grip area. Pick dehumidifier UD from the bottom to carry.

FAN SPEED:
Some models: this controls fan operation. Use desired setting.

HIGH -for faster moisture removal. LOW - for slower moisture removal.

If icing occurs, unplug dehumidifier turn off) until ice melts and room temperature rises.

(or