BENEFON TDP80DN
Instrukcja Serwisowa

Product: TDP80DN / 9.2.2001

BeneLoc

to install the BeneLoc Program. The Program suggests the following: C:\BeneApp\BeneLoc. Accept the drive and directory by clicking Next button. You can also type your own directory for BeneLoc Program. The Setup Program creates all necessary directories and subdirectories to your computer. Setup Program also creates its own group window in Program Manager.

4.0.2 To start the BeneLoc program
Connect the Service Localbox to serial port of your computer, which is called COM1 or COM2. The serial ports are usually located in the back of your computer, and more precise instructions can be found in the manual accompanying the computer. Adjust the Power Supply voltage to 4.0 Vdc. Connect the Service Localbox to the Power Supply. Connect the Service Adapter to the phone. Plug the cable with flat connector into the connector at the bottom of the phone. When the cable has been connected and the phone is switched on, the phone should be in LOCAL mode. You can test this by pressing arrow button. There should be ***Benefon local*** on the display, if not, clean connectors and try again. When phone is in LOCAL mode you can start the BeneLoc Program. To start the BeneLoc Program, double click the BeneLoc icon.

In the BeneLoc Startup window, first select the correct serial port. Then, you have to select type of the phone. After selection click OK to start BeneLoc Program. When operating without external power supply the phone may be on sleep mode and registration fails. You can wake up the phone by pressing some buttons on the phone.

3dp_80gb.fm

2