JVC TFHF40J
Instrukcja Serwisowa

TF-HF40(J)/TF-HF40-NK(J)

Creating an original model (Plate replacement)

TF HF40

Hook your fingernails on the

1

Turn the ring about 30 degrees hook your the left to detach it. fingernails on

Ring than your fingernails to turn it.

Turn the unit upside down as shown in the figure to detach the cap, film and design plate.

to turn,use something else other

Design plate Film Cap Ring

Indented part

Detaching the design plates

Creating an original model(Plate replacement)

Inserting original/additional design plates

raised parts of the ring as

Using the earphone
TF-HF40(J)
Hands Free Kits for Mobile Phones
For Mobile Phone / Cellular Phone with a �2.5mm triple-pole plug.
Using the earphone
Ear Hook Right Ear Ear Hook

2

1

TF-HF40-NK(J)
Hands Free Kits for Mobile Phones
For Mobile Phone / Cellular Phone with a �2.5mm triple-pole plug.
Insert your original or an additional design plate and cap in the design plate

including NOKIA 71xx/61xx/51xx Adapter
Using the earphone
Ear Hook Right Ear

proper order onto unit, attaching raised part of the design plate and cap to indented part of the headphone.

If your original plates are too thin to fit properly in the unit, place

supplied design plates under your originals to secure them tightly.

Ear Hook

Ear Pad Push the Ear Hook slightly. Place the Ear Hook over your ear and adjust the Ear Hook position to fit your To the �2.5mm ear. earphone jack. MICROPHONE VOICE MUTING BUTTON Ear Pad Place the Ear Hook over your ear and adjust the Ear Hook position to fit your ear. MICROPHONE

Push the Ear Hook slightly.
To the �2.5mm earphone jack or including Adapter.

Mobile phone/Cellular phone

VOICE MUTING BUTTON

Mobile phone/Cellular phone

the ring

2 Rear of 3

*Housing Ass'y

6
*Driver Unit Ass'y

5 4 3

1
*Cord

2

Note : These parts which was marked (*) will not be able to supply as our service parts.

Parts List
Item No. Parts No. Parts Name

Q'ty 1 1 1 1 1 1

Description

1 2 3 4 5 6

J46773-001 J46772-001 J46727-001 J46726-001 J46771-008 J46738-001

Pad Urethan Ear Pad Ring Cap film Sheet

Hologram

*Parts marked ( ) are safety parts. When replacing, be sure to use the specified one.

2 (No.70257)

You can download a variety of graphic plate designs from our World Wide Web server, and print out the

Disassembly

Insert ring,attaching 3 lines Turn the ring about 30 degrees

marked on therear of ring to the right until it clicks. position R displayed on the unit.

Make sure to shown in the figure above.

the raised parts Be careful not to damage your of the ring fingernails.If the ring is too hard

designs you like. (http://www.jvc.com)

Raised Supplied design plate part (use when original is too thin)

Ring Cap Original/additional