ASPECT Controls
The Plasma Display will allow you to enjoy viewing the picture at its maximum size, including wide screen cinema format picture. Press repeatedly to move through the aspect options: NORMAL ZOOM Panasonic AUTO [from the unit] Right side surface
ENTER/
FULL JUST
Note: When selecting an input slot that attaches BNC Dual Video Terminal Board (TY-FB9BD), Panasonic AUTO cannot be selected. The aspect mode changes each time the ENTER button is pressed.
+ -
/
VOL /
[During MULTI PIP Operations] � Picture and Picture, Picture in Picture :
NORMAL
FULL
� Others : Aspect switching is not possible. Notes: � For PC signal input, the mode switches between �NORMAL�, �ZOOM� and �FULL� only. � For a 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i, 750 (720) / 60p · 50p signal input, the mode is set to �FULL� mode, and switching is not possible. � Panasonic AUTO can be selected only during Video signal input. � The aspect mode is memorized separately for each input terminal.
Mode
4
NORMAL
Picture
Explanation NORMAL will display a 4:3 picture at its standard 4:3 size.
NORMAL
3
4
16
ZOOM
ZOOM mode magni�es the central section of the picture.
9
ZOOM
3
4
16
FULL
FULL will display the picture at its maximum size but with slight elongation.
9
FULL
3
4
16
JUST
JUST mode will display a 4:3 picture at its maximum size but with aspect correction applied to the center of the screen so that elongation is only
9
JUST
3
apparent at the left and right edges of the screen. The size of the picture will depend on the original signal. The display will automatically become enlarged (depending on the picture source), allowing you to view the picture at its maximum size.
4 3
16
Panasonic AUTO
9
Panasonic AUTO
For an elongated image
4 3
Image is expanded Changes in accordance with the Panasonic AUTO mode setting (see page 42).
Notes: � Panasonic AUTO mode is designed to automatically adjust the aspect ratio to handle a mix of 16:9 and 4:3 program material. Certain 4:3 program material, such as stock market data screens, may occasionally cause the image size to change unexpectedly. When viewing such programs, it is recommended that the ASPECT be set to NORMAL. � If adjusting the PICTURE V-POS/V-SIZE in Panasonic AUTO with FULL mode, the adjustment is not memorized. When exiting the mode, the screen will return to a former adjustment. � Panasonic AUTO can not be selected while BNC Dual Video Terminal Board (TY-FB9BD) is installed.
For a 4:3 image
Note: Do not allow the picture to be displayed in NORMAL mode for an extended period, as this can cause a permanent image retention to remain on the Plasma Display Panel.
