Adjustments Selects the proper brightness and density for the room. Adjusts for easier viewing of dark pictures such as night scenes and black hair.
Notes: (1) �Colour� and �Tint� settings cannot be adjusted for �RGB� and �PC� input signal modes. (2) You can change the level of each function (Contrast, Brightness, Colour, Tint, Sharpness) for each Picture menu. (3) The setting details for normal, dynamic and cinema respectively are memorized separately for each input mode (AV(S Video), Component, RGB and PC). (4) The �Tint� setting can be adjusted for NTSC signal only during �AV (S Video)� input signal.
Brightness
Darker Brighter
Colour
Less More
Adjusts colour saturation. Adjust for nice skin colour.
Reddish Greenish
Tint (NTSC only) Sharpness
Adjusts picture sharpness.
Less More
Note: In picture adjustment mode, bright pictures may not show any noticeable change when contrast is increased. Likewise, dark pictures will show little change when contrast is reduced.
Advanced Settings
Item Black extension W/B High R
Less More
Effect
Details Adjusts the dark shades of the image in gradiation.
Less
More
Adjusts the white balance for light red areas. Adjusts the white balance for light blue areas.
Less More
W/B High B W/B Low R
Less More
Adjusts the white balance for dark red areas. Adjusts the white balance for dark blue areas.
Less More
W/B Low B Gamma
Down Up
2.0
2.2
2.5
Notes: (1) Carry out �W/B� adjustment as follows. A Adjust the white balance of the bright sections using the �W/B High R� and �W/B High B� settings. B Adjust the white balance of the dark sections using the �W/B Low R� and �W/B Low B� settings. C Repeat steps A and B to adjust. Steps A and B affect each other�s settings, so repeat each step in turn to make the adjustment. (2) The adjustment values are memorized separately for each input mode (AV(S Video), Component, RGB and PC). (3) The adjustment range values should be used as an adjustment reference.
Helpful Hint (
N
/
Normalise
Normalisation)
On the remote control unit, while the �Advanced settings� menu is displayed, if either the N button is pressed at any time or the (ACTION button) is pressed during �Normalise�, then all adjustment values are returned to the factory settings.
