Adjusting POS. /SIZE
AUTO SETUP Automatically adjust H-POS / V-POS / CLOCK PHASE / DOT CLOCK and set H-SIZE / V-SIZE the standard value when RGB signal is input. Notes: � If the dot clock frequency is 162 MHz or higher, DOT CLOCK cannot be made. � If the image is that the edge is hardly �gured out or shadowy, that cannot be adjusted automatically. In such case, press AUTO SETUP again after changing the image to the clearer one. � When DVI-D is input, CLOCK PHASE cannot be adjusted automatically. � Select NORMALIZE in POS. /SIZE and press the ACTION ( ) button when appropriate adjustment cannot be made. Adjust the horizontal position.
H-POS
H-SIZE
Adjust the horizontal size.
V-POS
Adjust the vertical position.
V-SIZE
Adjust the vertical size.
DOT CLOCK
(During �COMPONENT�, �RGB� and �PC� input signal) Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust so that any such noise is minimized. (During �COMPONENT�, �RGB� and �PC� input signal) Eliminate the �ickering and distortion.
CLOCK PHASE
1:1 PIXEL MODE Adjusts the display size when 1125i, 1125p or 1250i signal is input.
OFF
ON
Notes: � Select ON when you would like to replay 1920 � 1080 input signal. � Applicable input signal; 1125 / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p · 1250i � Select OFF when �ickering is shown around the image. � H-SIZE, V-SIZE and DOT CLOCK cannot be adjusted when ON is selected.
Helpful Hint (
/
NORMALIZE
Normalization)
While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button is pressed during �NORMALIZE�, then all adjustment values are returned to the factory settings.
