Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
Connections
Do not connect the power cord until all other connections have been made.
This page is for TH-C9
Before connecting the speaker cords; Twist and pull the insulation coat off and remove.
Powered subwoofer TH-C9: SP-PWC9
Speaker cord (supplied)
� Connect the black cords to the black (r) terminals. � Connect the white cords to the (q) terminals referring to the table below:
FRONT SPEAKERS (LEFT) FRONT SPEAKERS (RIGHT) CENTER SPEAKER SURROUND SPEAKERS (LEFT) SURROUND SPEAKERS (RIGHT) White Red Green Blue Gray
Front speakers TH-C9: SP-THC9F
4m
10 m
Surround speakers TH-C9: SP-THC9S
4m Center speaker TH-C9: SP-THC9C
CAUTION
� When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer. � DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use � When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury. � Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup. � When holding a speaker, always grasp the lower portion. � Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.
