Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 99 (kliknij aby zobaczyć)
4.
Stoppers
3.
Loosen the clamping screws of the Ceiling Flush Mount Bracket.
� Loosen the three clamping screws (by turning them counterclockwise). � Make sure that the clamping brackets move inwards.
5.
*
4. 5.
Lower the Ceiling Flush Mount Bracket until the stoppers contact the ceiling plate. Push up the stopper release lever, marked (*) in the figure, using a screwdriver.
� While holding the Ceiling Flush Mount Bracket from below so that it does not drop, push up the one of the three stopper release levers marked (*)using a screwdriver or a similar tool. � If the ceiling plate is thick and the stoppers cannot be released easily, push up two of the stopper release levers (including the one marked (*)).
Release label
Push the stopper release lever upwards with a screwdriver, etc.
6.
6.
Pull out the Ceiling Flush Mount Bracket from the hole in the ceiling.
Tilt the Ceiling Flush Mount Bracket and move it obliquely downward to remove it.