Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
Installation and connection
Adjusting the Camera Angle (Continued)
Attach the dome cover.
Set the dome cover to the unit by aligning the 3 marks on the camera and dome cover (I, II and III).
Others
About White-spot correction
As a general characteristic unique to CCD, white spots may appear on the screen when operating under high temperature. In order to reduce this phenomenon, this unit is equipped with a white-spot correction feature.
FOCUS ADJ. OFF OFF OFF AUTO LL PHASE R ON ON-AGC ON-BLC MANU INT WHT.BAL. B
Usage
1. 2. 3.
Remove the dome cover. � Switch on the camera power supply and wait for at least 30 minutes. Cover the lens surface using a black sheet of paper, etc. so that light does not enter the lens. Press and hold the SPOT CORRECTION button on the unit for more than 2 seconds. � White-spot correction will start. Correction may take several seconds for completion.
CAUTION Be sure that the dome cover is firmly attached. Improper attachment could result in the cover dropping down.
SPOT CORRECTION
RESET
Memo: � The white-spot correction feature of this unit does not guarantee the correction of all white spots. Maximum correction: less than 16 ~ 32 spots Depending on the characteristic of white spots, correction may not be possible. � When performing white-spot correction, accurate data may not be achieved in case of highly-detailed pixels since correction is made using the information of surrounding pixels. � The result of white-spot correction is maintained until the next correction is performed.
