1. Attach the fall prevention wire to the
camera, followed by attaching it to the ceiling slab (Fall prevention wire is not included.) Connect the video signal cable. (A pg. 14) Lower the cover and connect the connectors. Upon connecting, cover the connectors using the protection cover. (A pg. 15) Install the Ferrite core (TK-C210FW only) (A pg. 14) Connect the alarm cable. (TK-C215V12 only) (A pg. 15) Wrap insulation tape around cables. Insert the camera unit into the ceiling hole.
1. Align j with the shooting direction when
mounting the camera.
2.
2. Fasten the camera. (x3 locations)
A Press the screw head of the clamping bracket
all the way in using a cross screwdriver.
B With the screw pressed in using the
screwdriver, turn about 90 in the clockwise direction, followed by pulling out the screwdriver.
3. Connect the input power supply cable. 4. 5. 6. 7.
C The clamping bracket is attached to the ceiling
and the camera fastened.
NOTE:
Dismantle the camera upon turning the screw heads of the ceiling mount bracket (x3) by 90 in the anti-clockwise direction.
7.
Fall prevention wire (not supplied) Protection cover
Alarm signal cable (TK-C215V12 only)
3.5. or crimp Solder
2.
Insulation tape
1.
6.
Wrap with tape
1.
F U RO P NT
Input power supply cable
B A
Align with shooting direction
2.
*TK-C215V4 is used in the above illustration
Adjusting Images
*TK-C215V12 is used in the above illustration
After mounting is completed, adjust the images while checking the actual image. (A pg. 23 AAdjusting ImagesB)