TOSHIBA TLP711U,E,H
Instrukcja Serwisowa

12. Leave the LCD block until the adhesive is hardened for a required time. In this case, place a thin paper on the LCD block to prevent dusts from entering. 13. When the adhesive is hardened, connect the FPC of the LCD to the connector of the PC board, and turn on the power. Check to see pixel deviation of the LCD. 14. Check to see dusts of the LCD. If dusts are found, remove them. 15. Turn the power off. Remove all the cables connected to the PC board and LCD panel, and remove the drive PC board. 16. Turn on the power and check operations.

Fig. 1-3-8

Fig. 1-3-9

Fig. 1-3-10

1-5