Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
Preparation
Installing the Input Card
1 2
Turn off the main power switch on the rear panel of the monitor and unplug the AC power cord from the AC outlet. Unscrew the screws and remove the slot cover from the input card slot on the rear panel of the monitor.
SLOT
REMOTE
MAKE/ TRIGGER
Slot cover
3
Insert the input card�s circuit board (green-colored) into the slot, fitting the board to the guide rails on the top and bottom of the slot.
Hold the tabs on the input card when inserting the input card. Fit the board to the guide rails.
NOTE: When installing IF-C21SDG/IF-C51SDG, you need to set the DIP switches on the input card correctly to use the functions of the input card. Refer to the instruction manual supplied with the input card and set the DIP switches beforehand.
SLOT
REMOTE
Tab
MAKE/ TRIGGER
Guide rails
Tab Input card (This illustration is IF-C01COMG.)
4 5
Push in the input card so that its front panel touches the rear panel of the monitor. Secure the Input Card by using the screws removed in step 2.
SLOT REMOTE
MAKE/ TRIGGER
NOTES: � The input card or the monitor may be damaged if you do not turn off the main power of the monitor before installing the input card. � Do not touch the terminals or the patterns on the circuit board of the input card. � Attach the slot cover when the input card slot is not in use.