Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
CHAPTER 1 INTRODUCTION
Installation
To install the TV
Downward spot lights or fluorescent lights in an overhead �Honeycomb� prevent direct illumination of the screen.
Where to install Place the TV on the floor or on a sturdy platform. The mounting surface should be flat and steady. If you install the TV on a soft floor, make sure that the floor is not damaged by the weight of the TV. Air Circulation Place the TV far enough away from the walls to allow proper ventilation. This will prevent the TV from overheating and avoid possible damage to the TV. Avoid dusty places too.
Use curtains or blinds to shut out direct sunlight.
Heat Damage Damage may occur if you leave the TV in direct sunlight or near a heater. Avoid places subject to extremely high temperatures or humidity, and temperatures of 41°F (5°C) or lower. Power Supply Plug the TV into an electrical outlet with standard household power (120 volt AC, 60 Hz). Do not change the plug�s safety prong. See page 2. Moisture Condensation If the room temperature suddenly rises (or if the TV is moved from a cool place to a hot place), condensation may occur on the lenses resulting in picture distortion or color fading. In such a case, simply wait a while (with the power on) and the condensation will evaporate.
Cover shiny surfaces (floor and walls) with nonreflective materials (carpet, rugs, wallpaper, etc.).
Best Viewing
Sit approximately 10-25 feet away from the TV. Sitting too far to the left or right of the screen will cause the picture to appear dull as will direct sunlight and room lights. Turn the TV off to check for reflections on the screen. Then remove the source of any reflections while viewing. VERTICAL VIEWING ANGLE [SIDE VIEW] HORIZONTAL VIEWING ANGLE [TOP VIEW]