ONKYO TS-SR701E
Instrukcja Obsługi

Using the macro function
Erasing a macro from the MACRO 1 (or 2) button
SEND/LEARN indicator

1. Press and hold down any one of the seven MODE buttons, press the MACRO 1 (or 2) button, and then release both buttons. When you press the MODE button, it lights and the SEND/ LEARN indicator lights. When you press the MACRO 1 (or 2) button, the indicator turns off. When you release the buttons, the indicator �ashes once. 2. Press the MACRO 1 (or 2) button again. The SEND/LEARN indicator slowly �ashes twice. The macro programmed to the MACRO button is erased. Notes: � If the SEND/LEARN indicator quickly �ashes three times and turns off, then the remote controller has exited the erasing mode because either you have made a mistake during erasing or a time-out has occurred because no button has been pressed. Resume from Step 1. � If you press a button other than MACRO 1 (or 2) button in Step 2, then you will in effect be overwriting the previous macro with a new macro.

MACRO 1

MACRO 2
MODE buttons

ENTER

Erasing all commands and macros that have been programmed
SEND/LEARN indicator

ON

STANDBY

This procedure will erase all the commands and macros that you have programmed into the remote controller and return it to its default settings. This operation will not affect the preset settings of the remote controller. 1. Open the battery cover and remove the batteries from the remote controller. 2. While pressing and holding down the ON and STANDBY buttons, re-insert the batteries in their correct orientation, and then release both buttons. The SEND/LEARN indicator �ashes slowly. 3. Press the ENTER button. The SEND/LEARN indicator lights up for about ten seconds and then turns off. All programmed commands and macros are erased and the remote controller returns to its factory presets. Notes: � Proceed to Step 3 immediately after Step 2; otherwise, the batteries will be consumed quickly. � If you press any button other than the ENTER button in Step 3, nothing will be erased. In this case, resume from Step 1.

ENTER

74