NUMARK TT-1520
Instrukcja Obsługi

TT1520

OPERATING INSTRUCTIONS
1. Push the power button to turn on the power. The speed indicator and the strobe-illuminator will light up. 2. Place a record on the turntable mat. When playing a 45rpm record with a large center hole, place the 45-rpm adapter on the center spindle. 3. Set the rotation speed (33/45) to match the record. 4. Remove the stylus protector and release the arm clamp. 5. Set the cueing lever to the up position. 6. Press the Start/Stop button. The turntable platter will start to rotate. 7. Move the tonearm over the desired groove. 8. Set the cueing lever to the down position. The tonearm will descend slowly onto the record and play begins. 9. To suspend play, lift tone arm with cueing lever. 10. When play is finished, raise the cueing lever, move the tonearm to the armrest, and secure the tonearm with the arm clamp. 11. Press the Start/Stop button to stop the platter rotating, push the power button to turn off the power.

PITCH ADJUSTMENT
The pitch control is variable in a range of +/-10%. During play, observe the strobe dots. If the strobe dots appear to the right, the pitch is slower than the rated speed. If flow to the left, the pitch is faster than the rated speed If the strobe dots appear stationary, which means the platter is in normal turntable speed, move the pitch control slider up or down to adjust the speed.

PLACEMENT
� � � �

Do not place the unit in a location where it will be exposed to direct sun light or near a heating appliance. Do not place the unit in a location where there is high humidity or a lot of dust. Cartridge may pick up slight sound pressure or vibrations of the speakers coming along the floor or through the air resulting in howling. Find a location, which is very stable and free of vibration. The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body horizontally. Clean the stylus periodically with a soft brush to prevent the accumulation of dust. When the sound becomes distorted or noisy, check the stylus. If worn out, replace it with a new one. From time to time, the dust cover and turntable cabinet should be wiped with a soft, dry cloth. Any volatile materials as alcohol, thinner, benzene, etc., may remove the paint or damage the luster, should not be used.

MAINTENANCE
� � �

SPECIFICATIONS
Turntable section Type Driving method Motor Turntable platter Turntable speed Starting torque Wow and flutter S/N ratio 2-speed, full manual Direct Drive 8pole,2phase, brushless DC motor Aluminum diecast 330mm dia. 33-l/3 and 45 rpm More than 600g-cm Less than 0.20% 55dB (DIN-B) Tonearm section Type Universal s-shaped tubular arm Effective length 220mm General Power supply AC110-127V/220-240V,50/60Hz Power consumption 20 Watts Dimension (WxDxH) 450 x 350 x 148 mm 17 3/4� x 13 3/4� x 5 7/8� Weight 7.5 Kgs 16 lbs

Specifications and design may be changed without notice for improvement - The Leader in DJ Technology
-7http://www.numark.com

©2000

Industries