jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 40 (kliknij aby zobaczyć)
4-3. FOCUS Adjustment of focus [TV / Measuring device setting] Input signal Dot pattern Adjustment point T601 (FBT upper SFR) MODE VIDEO 1. Input dot pattern with a pattern generator. 2. Adjust FBT upper SFR so that the dos on dot pattern are most focused. 4-4. WHITE BALANCE Adjustment of white balance This adjustment uses CA-100 (CRT COLOR ANALYZER). [TV / Measuring device setting] Adjustment menu number MENU5-1 / R CUT OFF MENU5-2 / G CUT OFF MENU5-3 / R GAIN MENU5-4 / G GAIN MENU5-5 / B GAIN Input signal PAL white luster (WHITE 100%) SPEC X=0.274, Y=0.286 Color temperature =11000°±1% MODE VIDEO * Apply aging for at least 20 minutes before adjustment. 1. Apply the CA-100 setting. (Fig. 4-3) 2. Adjust each CUT OFF and GAIN so that the X and Y values become within the range specified in SPEC. 3. After adjustment, check that the color temperature is ranged within 11000°±1%. [TV / Measuring device setting] Adjustment menu number MENU5-1 / R CUT OFF MENU5-2 / G CUT OFF MENU5-3 / R GAIN MENU5-4 / G GAIN MENU5-5 / B GAIN Input signal White luster (WHITE 100%) SPEC WHITE MODE VIDEO * Apply aging for at least 20 minutes before adjustment. * Repeat the whole steps (1 to 6) several times to complete this adjustment.
CA-100 SETTING
Fig.4-3
Fig.4-4
CUT OFF adjustment (LOW LIGHT): 1. Input white luster signal with a pattern generator. 2. Set the cutoff value of the most visibly strong color on the screen to �20�. Use the VOLUME + or - key on the jig remote controller, and adjust other two cut off values to obtain white picture. GAIN adjustment (HIGH LIGHT): 3. Use the VOLUME + or - key on the jig remote controller, and raise the level of R GAIN so that red shade is obtained. 4. Then, lower the level till red shade disappears. 5. Use the VOLUME + or - key on the jig remote controller, and raise the level of G GAIN so that green shade is obtained. 6. Then, lower the level till green shade disappears. 7. Use the VOLUME + or - key on the jig remote controller, and raise the level of B GAIN so that blue shade is obtained. 8. Then, lower the level till blue shade disappears. 9. Repeat the steps 1 to 8 till white shade becomes most visible. (Fig. 4-4) Note: After adjustment, apply the BRIGHT adjustment of adjustment menu 3-2.
