|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
THOMSON TX807 C/CS
Adjustments Alignments
Service Mode
It is necessary to enter the Service Mode in order to carry out alignment of the TV set. Most adjustments can be made with the RCU, except the Focus and Screen voltages. 1. Service Mode Access 1.1 With the RCU, switch the TV set into the �Standby� mode. 1.2 Switch �Off� the TV set by mains supply switch (wait until LED is dark). 1.3 Whilst pressing the �Magenta (text)� button on the RCU switch �On� the TV set using the mains switch. Continue to press the �Magenta (text)� button until the Service-setup Sub-menu appears. 3.2 The values will be stored in the non-volatile memory when leaving the service menu. 3.3 To leave the service menu press the �Exit� button on the RCU. 4. Temporary exit from Service Mode 4.1 To temporarily leave the Service Mode, press the �Exit� button on the RCU. To access the everyday menus, press the �Menu� button on the RCU. 4.2 To retum to the Service Menu, press the �Magenta� button on the RCU. 5. Leaving the Service Mode 5.1 To leave the Service mode either, switch the TV set into �Standby� or switch �Off� the mains supply.
2. Service Menu 2.1 Navigation - Press the / buttons to select the menu line. - Press the / buttons to make adjustments or selection of a menu item. 2.2 Service Sub-Menus Set-up lines (INIT, STANDARD, OSDCONTR) Geometry lines (HS,VS,VA,SC,VSH) Video lines (CL, BLORS/BLORP, BLOGS/ BLOGP,WPPRS/WPRP,WPGS/WPGP, WPBS/ WPBP, PWS/PWP, BKS,YD) IF lines (TOP) Video Processor (CD0, CD1, SYN0, SYN1, DEF, VI0, VI1, SOUND, CONT0, CONT1, FEAT0). 2.3 Activation of a line: The first line (1) is continuously displayed. Sequential selection of the others is possible by pressing the / buttons on the RCU. The selected line will be highlighted in YELLOW text. 3. Alignment and storing new function value 3.1 The current value of the selected funcfion is displayed in a hexadecimal form to the right of the function name. This value is adjusted by means of the RCU / buttons.
|
