ONKYO TXHT490
Instrukcja Serwisowa

TX-DS494/HT-R490 ADJUSTMENT PROCEDURES
IDLING CURRENT ADJUSTMENT
1. Before Idling adjustment, turn the trimming resistors R573, R574, R673, R674 and R1532 to counter clockwise. 2. Connect the DC voltmeter to sockets P511,P512, P611, P612 and P1511. 3. After turn POWER to ON, adjust the trimming resistors R573, R574, R673, R674 and R1532 so that the reading of voltmeter becomes 2.4 to 2.6 mV. 4. After adjustment, attach the top cover. 5. Confirm the voltage of above points after five minutes. 6. When 3.1 mV to 6.4 mV : Readjust the trimming resistors above so that the voltage becomes 6.5 to 6.7 mV. When 6.5 mV to 7.5 mV : It is not necessary to adjust. When 7.6 mV to 13 mV : Readjust the trimming resistors above so that the voltage becomes 7.5 to 7.7 mV.

[Note] No load and No signal

Front Lch

Front Rch

P511

P512

R573

R574

Front side Front side

R1532

P612

R674

R673 P611

P1511

Center ch

Surround Rch

Surround Lch