|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Advanced Setup�Continued
Speaker Distance
To get the best from surround sound, it�s important that the sound from each speaker reaches the listener at the same time. To achieve this, you need to specify the distance from each speaker to the listening position. Notes: � The Center and Subwoofer distances can be set up to 5 ft. (1.5 m) more or less than the Front distance. For example, if the Front distance is set to 20 ft. (6 m), the Center and Subwoofer distances can be set between 15 and 25 ft. (4.5 and 7.5 m). � The Surround and Surround Back distances can be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the Front distance. For example, if the Front distance is set to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back distances can be set between 5 and 25 ft. (1.5 and 7.5 m).
1 2
RECEIVER
Measure and make a note of the distance from each speaker to the listening position. Press the [RECEIVER] button followed by the [SETUP] button on the remote controller.
Speaker Levels
With this function, you can adjust the volume of each speaker so that all speakers can be heard equally at the listening position.
Speaker levels cannot be adjusted while the AV receiver is muted.
3
Use the Up and Down [ ]/[ ] buttons to select �2. Sp Distance,� and then press the [ENTER] button.
1
RECEIVER
Press the [RECEIVER] button followed by the [SETUP] button on the remote controller.
4
While �Unit� is displayed, use the Left and Right [ ]/[ ] buttons to select �feet� or �meters�. feet: Distances in feet. Can be set from 1 to 30 feet in 1-foot steps. meters: Distances in meters. Can be set from 0.3 to 9 meters in 0.3-meter steps. Use the Down [ ] button to select �Front,� and use the Left and Right [ ]/[ ] buttons to specify the distance for the �front speakers,� then press the Down [ ] button to select the next speaker.
2
Use the Up and Down [
]/[
]
buttons to select �3. Level Cal,� and then press the [ENTER] button. A pink noise test tone is output by the front left speaker.
5
3
6
Repeat step 5 for all speakers. Note: Speakers that you set to No or None in the Speaker Con�guration (page 32) cannot be selected.
Turn up the volume so that you can hear the test tone suf�ciently. While each speaker outputs the test tone, its name appears on the display, as shown.
7
Press the [SETUP] button. Setup closes.
48
|
|
|
> |
|
