Door reversal
Before starting work, unplug the appliance. To reverse the opening direction of the door, proceed as follows: 1. Pull off the ventilation grille (D), which is a clip-on fit. Remove the bottom hinge (E) by unscrewing its two fixing screws. 2. Remove the plugs (G) and fit them on the opposite side. 3. Remove the door (4). 4. Unscrew pin (2) and screw it onto the opposite side. 5. Refit the door. 6. Refit the bottom hinge on the opposite side using the two screws previously removed. 7. Slide the hole cover (F) off the ventilation grille (D) and fit it on the opposite side. 8. Refit the ventilation grille, clipping it into place. 9. Remove the clip-in screw covers, then move the handle to the opposite side. Holes which are not used must be masked with the plastic plugs previously removed from the opposite side. Warning! If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
Inner door reversal
1. Using a screwdriver release bracket (1) by pressing on the internal spring (Fig.) and withdraw it from its seat together with the door; 2. remove plug (2) and fit it in the hole left open on the opposite side; 3. turn the door through 180°, remove the bracket (1) and refit it on the opposite side. 4. Refit the door and insert the top pin and bottom bracket (1), pushing it into place. To ensure correct storage of food, the door is fitted with a simple spring device which holds it in the open position until it is properly closed.
