TEAC UX-1
Instrukcja Serwisowa

EXPLODED VIEW-2
REF.NO.
2-56 2-57

PARTS NO.
5785304100 M0187931

DESCRIPTION
WASHER,POLY 4.1X6.5X0.25T CABLE CLAMP,NYLON AB-5N

REMARKS

2-61 2-62 2-63 2-64 2-65 2-66 2-67 2-68 2-69 2-70 2-71 2-72

B00145800A B00053800A B0006360 5780102008 5780013006 5780102604 5780002603 5780103004 5780102606 5780103003 5780024008 5780023008

SCREW,JHA 4X20FZC SCREW,MPAR 2X3FNI SCREW,MPPR 1.7X5.0 SCREW,PAN M2X8 SCREW,BPA 3X6FNI SCREW,PAN SCREW,BPA SCREW,PAN SCREW,PAN SCREW,PAN M2.6X4 2.6X3FZC M3X4 M2.6X6 M3X3

SCREW,BPA 4X8FNB SCREW,BPA 3X8FNB

Cautions about Disassembly and Mounting
�

After joining CLAMPER MAGNET 1 and DISC CLAMPER 2 with adhesive, ThreeBond 1359D, harden forced out surplus adhesive with UV irradiation. Avoid applying a strong pushing force to the PU BASE ASSY when removing/installing the PUSH SW 9. When fastening the SA SLED MOT ASSY a, push it against the locating pin.

�

For the MOTOR HOUSING ASSY, first fully tighten down the screws on the left end viewed from the front.

�

�

First tighten down these screws

HOUSING ASSY,MOTOR

�

Avoid disassembling parts that are not "exploded" in the diagram (such as PU BASE ASSY, MOTOR HOUSING ASSY). Dedicated tools are required to assemble them. When those parts are needed to replace, the MECH UNIT itself should be replaced.

�

Fasten the STOPPER BELT PLATE @ so that there is a clearance of 1 mm between it and PULLEY (B) PLATE ..
PLATE,PULLEY(B) PLATE,STOPPER BELT

1mm

�10�