SHARP UX-1100
Instrukcja Serwisowa

UX-1100DE FO-1450DE

3. Assembly and connections

4. Loading printing paper
The paper tray holds the paper on which received documents and copies are printed. Up to 300 sheets of A4 size paper from 60 to 90 g/cm2 can be loaded in the tray. For the best results, we recommend that you use Sharp FO-16NC (A4 size) paper.

1 Plug the power cord into a 220-230 V, 50 Hz, grounded (2-prong)
outlet. Caution: Do not plug the power cord into any other kind of outlet. This will damage the machine and is not covered under the warranty.

1

If the paper tray is in the fax machine, remove the cover. Grasp the end of the paper tray, lift it slightly, and pull it out of the fax machine.

AC outlet

�

Important: You must remove the paper tray from the fax machine to add paper.

2 Insert one end of the telephone line cord into the "TEL. LINE"
Be sure to insert the telephone line cord into the "TEL. LINE" socket. Do not insert it into the "TEL. SET" socket.

jack. Insert the other end into a standard single-line telephone wall socket.

2 Push the pressure plate down until it locks into position.

To AC outlet
TEL SET. TEL. LIN E

3 Fan the paper and then place it in the paper tray, print side up.
Make sure the corners of the paper go under the holders, and then shake the tray gently to straighten the paper.
Wall socket

3 Attach the received

document tray by inserting the tabs into the holes at the rear of the fax.

1�6