JVC UX-A7DVDUD
Instrukcja Obsługi

Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing. When shipped, the built-in AM tuner is set to 9 kHz spacing. You can change it to 9 kHz or 10 kHz spacing. On the main unit ONLY: To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet. While holding ¢, press . The unit turns on and tunes in to 530 kHz. To set it back to the 9 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet. While holding 4, press . The unit turns on and tunes in to 531 kHz.

To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception. On the remote control ONLY: Press FM MODE. � Each time you press the button, FM reception mode alternates between STEREO and MONO. STEREO: Normally select this. You can hear stereo sound when a program is broadcast in stereo. The STEREO indicator lights while receiving the FM stereo broadcast (only when the reception is good). MONO: Select this when an FM stereo broadcast is noisy or hard to receive. Reception improves though stereo effect is lost. The MONO indicator lights up on the display.

When you change the AM tuner interval spacing The preset stations you have set (both FM and AM) will be erased. In this case, preset stations again. See �Presetting Stations� on the next page.

Tuning in to a Station

1 Press FM/AM to select either �FM� or �AM.�
When you press the button for the first time, the unit automatically turns on with the last selected band. � Each time you press the button, the band alternates between FM and AM.

2 Press and hold ¢ or 4 (or UP or DOWN on the
main unit) until the station frequencies start changing continuously in the main display. � ¢ (UP): Increases the frequencies. � 4 (DOWN): Decreases the frequencies. The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. � If an FM program is broadcast in stereo, the STEREO indicator lights up on the display. To stop during searching, press ¢ or 4 (or UP or DOWN on the main unit).

When you repeatedly press ¢ or 4 (or UP or DOWN on the main unit) The frequency changes step by step.

25