Listening to FM and AM Broadcasts
Tuning In a Station
1 When the unit is turned on, press TUNER/BAND to select tuner mode.
The unit tunes in the last station tuned in (either FM or AM).
BAND
Presetting Stations
You can preset 20 FM and 20 AM stations. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
BAND
TUNER
2 Press TUNER/BAND to select the band, FM or AM.
Each time you press the button, the band selection alternates between FM and AM.
1 Tune in the station you want to preset.
� See �Tuning In a Station� on the left.
TUNER
2 Press PROGRAM.
SEARCH/TUNING
PROGRAM
3 Press and hold 4 or ¢ for more than 1 second.
The PROGRAM indicator and �00� start blinking on the display.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the STEREO indicator lights up.
3 Press PRESET � or 5 (or PRE DOWN 8/2 or PRE UP 3/8 on the remote control) to specify the desired preset number.
PRESET DIRECTION PLAY/PAUSE
To stop searching, press 4 or ¢.
notes
4 To preset more stations, repeat steps 1 to 3 above, allocating a different preset number to each station.
notes
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To improve the FM reception
When an FM stereo broadcast is hard to receive or noisy, press REPEAT ST/ MONO to switch to the monaural reception. The STEREO indicator disappears from the display.
ST/MONO
When a new station is stored The station previously memorized with the same preset
REPEAT
number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station
1 Press TUNER/BAND to select tuner mode.
BAND
To restore the stereo reception, press REPEAT ST/MONO again so that the STEREO indicator lights up.
TUNER
To change FM/AM tuning interval
The unit�s default tuning interval is 100 kHz/step for FM reception and 10 kHz/step for AM. You can change this setting to 50 kHz/step for FM and/or 9 kHz/step for AM when using the unit in an area of different frequency allocation system. 1 Press TUNER/BAND to select �FM� or �AM�. 2 While holding down STOP/CLEAR 7 on the unit, press VOLUME + repeatedly to select the desired tuning interval.
2 Press TUNER/BAND to select the band, FM or AM. 3 Press PRESET � or 5 (or PRE DOWN 8/2 or PRE UP 3/8 on the remote control) to select the desired preset number.
PRESET DIRECTION PLAY/PAUSE