JVC UX-P38VUB
Instrukcja Obsługi

English

Common Operations
Turning On the Power
When you press the play button � CD 3/8 SELECT, TAPE 2 3, or the source selecting button � FM/AM and AUX, the unit automatically turns on and starts playback if the source is ready. To turn on the unit, press STANDBY/ON. The STANDBY lamp on the unit lights green.

2 Press ¢ NEXT or PREV
4 to adjust the hour, then press CLOCK.
The minute digits start flashing on the display.

3 Press ¢ NEXT or PREV
To turn off the unit (on standby), press STANDBY/ON again. The STANDBY lamp lights red. � The CLOCK indicator flashes on the display until you set the built-in clock. After setting the clock, the clock time will appear on the display while the power is off. � A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.

4 to adjust the minute, then press CLOCK.

The CLOCK indicator remains lit on the display.

To check the clock time
Press DISPLAY on the remote control (or CLOCK on the unit) while playing any source. � Each time you press the button, the source indication and the clock time alternate on the display.

When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away, while the tuner preset stations (see page 11) will be erased in a few days.

� When you unplug the AC power cord or if a power failure occurs, the clock loses the setting and is reset to �0:00.� You need to set the clock again. � The clock may gain or lose 1 to 2 minutes per month.

Setting the Clock
Before operating the unit any further, first set the clock built in this unit. When you plug the AC power cord into the wall outlet, the CLOCK indicator starts flashing on the display. You can set the clock whether the unit is on or off. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Setting the AM Tuner Interval Spacing
When shipped, the AM tuner interval is set to 10 kHz or 9 kHz spacing. You can change it to 10 kHz or 9 kHz spacing.

On the unit ONLY:
To select 10 kHz intervals, while holding down ¢ NEXT in standby mode, press STANDBY/ON to turn on the power (at the same time, the 10 kHz spacing is selected for AM broadcast.) To select 9 kHz intervals, while holding down PREV 4 in standby mode, press STANDBY/ON to turn on the power.
[10 kHz Intervals] [9 kHz Intervals]

On the unit ONLY:

1 Press CLOCK for more than 2
seconds.
The hour digits start flashing on the display.

When you change the setting The preset stations are erased. You will need to preset the stations again. (See page 11.)

�9�