|
Kto jest w sklepie?
Sklep przegląda 5975 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
English
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations using the Remote Control. Note: Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.
CAUTION: Even if the system is unplugged or if a power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.
Presetting stations manually ��������
UP
SET
FM/AM SET
Changing the FM Reception Mode
When you have tuned into an FM stereo broadcast, the STEREO indicator lights up and you can hear stereo effects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effects.
STORED
SET
or
When changing the Band
DOWN
(Within 5 seconds)
FM = 30, AM = 15
1 Select a band by pressing the FM/AM button. 2 Press the 4 or ¢ button to tune in a station. 3 Press the SET button.
�SET� will flash for 5 seconds. Within 5 seconds, proceed to the next step. When the display returns to the one set in Step 2 after 5 seconds, press the SET button again.
Press the FM MODE button on the Remote Control so that the MONO indicator lights up on the display.
FM MODE
STEREO MONO To restore the stereo effect, press the FM MODE button on the Remote Control so that the MONO indicator goes off.
4 Press the UP, DOWN, > or < button within 5 seconds to select the preset number.
UP or > button: Increases the preset number by 1. DOWN or < button: Decreases the preset number by 1. � When the > or < button is held down, the preset number changes rapidly.
5 Press the SET button within 5 seconds.
�STORED� appears and after 2 seconds, the display returns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as above.
Presetting stations automatically ���
In each band, you can automatically preset 30 FM and 15 AM stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency to the highest frequency.
FM/AM AUTO PRESET
(For more than 2 seconds)
1 Select a band by pressing the FM/AM button. 2 Press the AUTO PRESET button on the Remote Control for more than 2 seconds. 3 Repeat steps 1 and 2 for the other band.
9
English
s If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.
|
|
|
> |
|