NIKON VAA11904
Instrukcja Serwisowa

VAA11901-R.3579.A

(Note) If the rack plate is removed or the cam is
Cam Rack plate

not in the right position, assemble the rack plate by following way. � Move the finder lens to the right end. � Set the horizontal line on the cam to the center of the cam shaft. � Assemble the rack plate by sliding it in a direction pointed by an arrow. � After assembling them, be sure to check the position as mentioned in Page A1.

Finder lens

3. Lens unit

� Attach the 3 pieces of spacers shown in Picture on the left to the lens unit. � Set the finder coupling pin and the claw of lack plate on the finder unit. Then attach the finder unit with the 3 screws � (1.4 x 3.5). � Apply a piece of tape (brown) and spacer to the bottom of the lens unit.
Spacer

Finder coupling pin

Lens unit Finder unit Spacer(Brown)

� Spacer(Brown) Spacer

Spacer

[Position where the tape and spacer should be applied.]

- A2�E4500 -