SHARP VC-A550X
Instrukcja Serwisowa

VC-A300X/NZ VC-A550X

INSTALLING THE MASTER CAM (AT REAR SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as shown below. 2. Place the master cam in the position as shown below.

REPLACEMENT OF LOADING MOTOR
� Removal

E ring (XRESJ30-06000) Master cam Apply grease Apply grease

Fully turn clockwise

Fully turn counterclockwise Face the wide tooth side ward No grease

Figure 4-44-1.

Note: See the figure below for the phase matching between the master cam and the casecon drive gear. 3. Finally fix with the E ring.
Master cam

Figure 4-45.

Casecon drive gear

Half-round notch Round mark

� Replacement Remove the loading motor, and install the replacement loading motor as shown below.
10.2 +0.2 mm �0.2

When installing the master cam, align the casecon drive gear round mark with the half-round notch of master cam.

Figure 4-44-2.

Figure 4-46. The loading motor pressing-in must be less than 147 N (15 kgf). Adjust the distance between motor and pulley to 10.2 +0.2 mm).
�0.2

27