SHARP VC-MH770SM
Instrukcja Obsługi

ADVANCED OPERATION

PLAYBACK OF A VIDEO TAPE
CHECKING THE AMOUNT OF TAPE REMAINING
When you load a video tape into the VCR it can calculate approximately the amount of video tape remaining in hours and minutes. This is useful in determining whether or not there is sufficient tape left to make a recording. When a video tape is playing, the amount of tape remaining is calculated for you automatically. To display the amount of video tape remaining:

1. Load the video tape into the VCR 2. Press DISPLAY on the remote control as many times as necessary until �R� appears on
the VCR display. The tape will wind forward and then return to its original position. The tape remaining will be shown on the VCR display in hours and minutes. For example: In Standard Play, 1 hour 23 minutes is left on the tape:

In Long Play, 2 hours 46 minutes is left on the tape:

In Extended Play, 4 hours 9 minutes is left on the tape:

NOTES:
� � Do not interrupt the tape remaining calculation. If less than 5 minutes of tape remains the display will flash.

PLAYING BACK A VIDEO TAPE REPEATEDLY
You can set your VCR to automatically rewind at the end of playing a video tape and replay the entire tape again. REPEAT will appear on the on-screen display when selected. To use this feature:

1. Press MENU to display the main menu on the
screen.

MODE MENU SCREEN
B L U E MU T E �R E P E A T AU T O ON OF F OF F

2. Press [K/L] to select MODE. 3. Press SET. 4. Press [K/L] to select REPEAT. 5. Press [H/J] to select ON. 6. Press SET. 7. Press MENU to return to normal screen.
GB-16

SET

: SE L ECT : ENT ER

: CHANGE ME NU : E X I T