Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 28 (kliknij aby zobaczyć)
Setup
Setup
Power supply
Power supply
Charging the battery
When this unit is purchased, the battery is not charged. Charge the battery before using this unit. � If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove the DC cable from the AC adaptor.
1 Connect the AC cable to the AC adaptor and the AC outlet. 2 Put the battery on the battery mount by aligning the mark, and then securely plug it in.
� The output plug of the AC cable is not completely connected to the AC adaptor jack. As shown in A, there is a gap.
A
� Charging lamp Lights up: Charging Goes off: Charging completed Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start. When the battery temperature is excessively high or low, the CHARGE lamp flashes and the charging time will be longer than normal.
� Battery charging time (l 29) � We recommend using Panasonic batteries. � If you use other batteries, we cannot guarantee the quality of this product.
Fitting the battery Push the battery against the battery holder and slide it until it clicks.
Removing the battery While sliding the BATTERY RELEASE lever, slide the battery to remove it.
� Hold the battery with your hand so it does not fall.
LSQT1011
28
� Before removing the battery, be sure to set the OFF/ ON switch to OFF and check that the status indicator is off before removing the battery.