Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 17 (kliknij aby zobaczyć)
Adjusting the Grip Strap 1
Open the hand strap flap (Q) and grip strap (W).
When recording, remove the lens cap (Q) and attach the lens cap cord to the fastener (W) so the lens cap will not get in the way.
Fastener
Preparation
2
Loosen the grip strap, pass your hand through the loop and put your thumb close to the Power Zoom control. Then pull the grip strap tight until it fits snugly.
Note: � Always replace the lens cap on the lens when the VIEWCAM is not in use.
Attaching the Shoulder Strap 1 2
Hold one end of the strap and thread it through the loop on the left side of the LCD screen. Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown. Draw the strap in the direction of the arrow to secure. Use the same procedure to attach the other end of the strap to the loop on the lens side.
3
Seal the velcro closure of the grip strap (Q) and close the hand strap flap (W).
3
4�6
1
4
Caution: � Do not swing the VIEWCAM by the hand strap.
2
5
Buckle
Using the Lens Cap
Attach the lens cap cord to the VIEWCAM as shown below (Q), and attach the lens cap to the lens (W).
Buckle
3
6
12
VL-SD20S-GB/pp. 008-016; 99/8/10/18:00 G. K . A s s o c i a t e s , To k y o
