HELICON VOICECRAFT
Instrukcja Obsługi

Option 2: Upgrade Procedure Using MIDI to Update Software
Requires #2 Philips screw driver 1. Unplug the power cable from the VoicePrism. 2. Remove the top of the VoicePrism by removing 7 screws. 3. Remove the back plate on the VoicePrism reserved for the VoicePrismPlus expansion card by removing 4 screws. 4. Press the plastic standoff into the hole labeled MTH4 on the main circuit board in the VoicePrism, as indicated in Figure 1. 5. The red stripe on the ribbon cable connected to the VoiceCraft card indicates pin1. Align the connector on the ribbon cable with J12 header making sure that pin 1 on the cable is oriented correctly with pin 1 of J12. 6. CAREFULLY press the ribbon cable connector onto J12. 7. Position the VoiceCraft card so that the standoff is aligned with the corresponding hole on the VoiceCraft Card. 8. Press the VoiceCraft card down so that the standoff presses into the card. 9. Attach the plate of the VoiceCraft card to the back panel of the VoicePrism using 4 screws removed earlier. 10. Put the top cover back on to the VoicePrism using 7 screws removed earlier. 11. Plug the power cable into the VoicePrism and power up the unit. 12. Make note of the current version number (press the Utility button and tab to the Version page). 13. Tab to the Upgrade page, one page to the right of Version. 14. Enter the upgrade code �H�, �V�, �K�. 15. Press soft knob 1 and select �EXECUTE� from the popup menu. 16. A message box titled �ARE YOU SURE� will be displayed. If you want to proceed select �YES� and press soft knob 1.