PHILIPS VR752/58
Instrukcja Obsługi

1. Connecting the video recorder
Preparing the remote control for operation
The remote control and its batteries are packed separately in the original video recorder packaging. You must install the batteries in the remote control before use.

Connecting with a scart cable
Have the following cables ready: - One aerial cable (1, supplied) - One scart cable (2, not supplied)
1 2

1.Remove the aerial 1.
cable plug from your TV. Insert it into the AERIAL at the back of the video recorder.
AV 1 (TV)

AERIAL
AUDIO OUTPUT L R

AERIA L RF OUT

2.Insert one end of the 2. 1.Take the remote control and the enclosed 1.
batteries (2 batteries). supplied aerial cable into the RF OUT at the back of the video RF OUT recorder and the other end into the aerial input socket at the back of the TV. 3.Plug one end of a scart cable into the scart 3. socket AV1(TV) at the back of the video recorder and the AV1(TV) other end into the
AV 1 (TV)
RF OUT AERIA L OUTPUT AUDIO L R

2.Open the remote control�s battery compart2.
ment and place the batteries in it as shown in the picture and close the battery compartment. The remote control is now ready to use. Its range is approximately 7 metres.

1 (TV)

AUDIO OUTPUT

AERIA L

L

Connecting your video recorder to the TV
The necessary cable connections must be made before you can record or playback TV programmes using your video recorder. We recommend that you use a scart cable to connect your TV and video recorder. What is a scart cable? The scart or Euro AV cable serves as the universal connector for picture, sound and control signals. With this type of connection, there is practically no loss of quality during the picture or sound transfer. � You can have the Hi-Fi sound on the TV only with a scart cable.

RF OUT

R

suitable scart socket on your TV reserved for the video recorder operation (see your TV�s operating instructions). 4.Switch on the TV. 4. 5.Insert AC cable into the wall socket. 5. My TV has several scart sockets. Which one should I use? Select that scart socket which is suited for the video output as well as for the video input. My TV has a configuration menu for the scart socket. Please configure this scart socket as InputOutput.

6.If the connection was properly made and 6.
your TV was automatically switched to the programme number for the scart socket, you will see the following picture:

PUSH MENU TO CONTINUE

4

EN